Technician A says that aluminum brake drums use cast iron friction surfaces. Technician B says that up to 0.030 in. (0.8 mm) should be left after machining a drum to allow for wear. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician


C

Trades & Technology

You might also like to view...

As the Revolution approached, Presbyterian and Congregational ministers in general

A. remained neutral. B. supported the Revolutionary cause. C. sided with the Anglican clergymen. D. opposed the idea of revolution. E. split on the issue of independence.

Trades & Technology

A project manager can control overruns by _____.

a. tracking actual costs b. tracking estimated costs c. reviewing historical cost data d. tracking projected costs

Trades & Technology

If REAR toe is uneven, the vehicle will pull to the side with the ________ toe-in

A) Least B) Most

Trades & Technology

When debrazing a joint on a refrigeration system, often:

A) The exiting fumes will extinguish the torch flame. B) The oil fumes will ignite when the joint is opened. C) The residual refrigerant will crystallize around the tube outlet. D) The vacuum created by the flames will cause a quick inward suction when the tube is pulled.

Trades & Technology