What do the alternator slip rings and brushes connect to?
A. Ground.
B. Stator windings.
C. Alternator output circuit.
D. Rotor field windings.
Answer: D
You might also like to view...
The adjacent noncorner tilt-up wall panels ________.
A) should not be connected unless the building is located in a seismic region. B) are connected using 6 in. × 6 in. steel plates at 6 ft on center. C) should not be connected unless the building is located in a seismic or high-wind region. D) are connected using a continuous steel plate extending from the bottom of the panel to its top.
The _____________________ will consist of a question and answer period between the student and judges
Fill in the blank(s) with correct word
A technician connects one lead of a digital voltmeter to the positive (+) terminal of the battery and the other meter lead to the battery terminal (B) of the starter solenoid and then cranks the engine. During cranking, the voltmeter displays a reading of 878 mV. Technician A says that this reading indicates that the resistance of the positive battery cable is too high. Technician B says that
this reading indicates that the starter is defective. Who is right? A) A only B) B only C) Both A and B D) Neither A nor B
The ring around the 6GR all-position pipe is there to ________ the operation
A) Restrict B) Balance C) Hold heat for D) Improve E) None of the above