Which of the following is NOT part of a stall test procedure?
A) Run the engine at 2000 rpm for 2 minutes then turn OFF the key
B) Shift the transmission into neutral and run the engine at 1000 rpm for at least 60-seconds following a stall test.
C) Connect a tachometer and block the drive wheels
D) Place the gear selector in gear and depress the accelerator making sure that the parking and service brakes are firmly applied
A
You might also like to view...
The output of the ac module shall be considered an inverter ____.
a. output cycle b. source cycle c. output circuit d. source circuit
Technician A says that a wastegate is used on most turbocharger systems to limit and control boost pressures. Technician B says that a relief valve is also used to keep the speed of the turbine wheel from speeding up during engine deceleration. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
What two circuits can most fuel subsystems be divided into?
A. Primary and secondary circuits. B. Filtered circuit and non-filtered circuit. C. Fuel and lubrication circuits. D. High pressure and low pressure circuit.
Which of the following is an actuator that has a stationary permanent magnet and a coil that moves?
A. LVDT B. ac induction motor C. solenoid D. voice coil E. encoder