If a feature is at its maximum material limit everywhere, ____ errors of straightness are permitted.
A. limited
B. maximum
C. minimum
D. no
Answer: D
Trades & Technology
You might also like to view...
The effects of an excessive feed rate are:
A) Cutting edge chipping and possible broken cutters B) Long lasting cutting edges C) Very good surface finish D) Rapid cutting edge wear
Trades & Technology
A D-MOSFET operating in its depletion mode works very much like a(n)
A) PNP bipolar transistor B) N-MOSFET C) NPN bipolar transistor D) JFET
Trades & Technology
To eliminate unwanted oscillations
A) add bypass capacitors to power supplies B) check ground paths C) use capacitive coupling at inputs D) all the above
Trades & Technology
The weight of the components not supported by the springs is known as [?] weight
What will be an ideal response?
Trades & Technology