How much transmission fluid should flow through the cooler?
A. One quart per minute
B. Two quarts every 30 seconds
C. Two pints per minute
D. Two quarts per minute
Answer: B. Two quarts every 30 seconds
You might also like to view...
By 1860, life for slaves was most difficult in the
A. Atlantic states of North and South Carolina. B. Deep South states of Georgia and Florida. C. territories of Kansas, Nebraska, and New Mexico. D. upper South states of Virginia and Maryland. E. the new southwest states of Alabama, Mississippi, and Louisiana.
How long does the electric fuel pump run if the ignition is turned on but the engine is not started?
A) A few seconds B) Until the ignition is turned off C) Five hundred milliseconds D) 5-10 minutes depending on vehicle
What problems can be caused by overlubricating a blower motor?
A) The blower motor could run faster than specifications recommend. B) The motor would run more effectively with the extra lubrication. C) This could eventually cause the motor windings to short out. D) It is not possible to overlubricate a motor.
Cutting a 2" (5 cm) aluminum plate requires a(n) _____
a. low gas flow rate b. high-cutting amperage c. low-cutting amperage d. oxygen/air plasma/shield gas combination