A typical transaxle repair kit includes ________.

A) Snap rings
B) Seals
C) Gaskets
D) All of the above


Answer: D) All of the above

Trades & Technology

You might also like to view...

The fuel used per person for mass transportation compared to travel in a single occupancy vehicle is _____.

a. about the same b. much higher c. much lower d. slightly lower

Trades & Technology

All of the following experience increased protein content as a result of good nitrogen nutrition

EXCEPT ____.

a. forages b. feeds c. algae d. human foods

Trades & Technology

Which circuit below has the diode in the proper place to provide flyback protection for switching the inductive load on and off?

A.


B.


C.


D.


E. None of the circuits above is properly set up for flyback protection.

Trades & Technology

The difference between a liquid receiver and a suction accumulator is that:

A) Receivers receive the refrigerant that accumulators accumulate. B) A liquid receiver is used after the evaporator on the high side. C) An accumulator is located on the high side just before the condenser. D) Receivers only allow liquid to leave while accumulators only allow vapor to leave.

Trades & Technology