When changing a low-voltage transformer, the service technician should:

A) Temporarily short across the secondary side of the transformer to test its output.
B) Check all low-voltage controls for shorts and grounds.
C) Use a replacement transformer with a higher-voltage primary winding to make it last longer.
D) Use a replacement transformer with a higher VA rating to make it last longer.


B

Trades & Technology

You might also like to view...

What is the minimum efficiency of a fossil fuel–burning furnace?

What will be an ideal response?

Trades & Technology

A three-phase, four-wire system operating with a 480-V line voltage is shown in Fig. 12.71. The source voltages are balanced. The power absorbed by the resistive wye-connected load is measured by the three-wattmeter method. Calculate:

Trades & Technology

SPI stands for synchronous pipelined interface

Indicate whether the statement is true or false

Trades & Technology

When a sawtooth wave is applied to a differentiator op amp, the output is a(n) __________.

A. inverted and amplified sawtooth B. square wave C. sine wave

Trades & Technology