ASE-Style Multiple Choice
While having a discussion, Technician A says that sheet metal lowering means to work a dent outward or away from the body. Technician B says that sheet metal lowering means to work a high spot or bump down or into the body. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: B
You might also like to view...
Which of these describes electrical power?
A) Volts B) Watts C) Amps D) None of these
Which of the following statements is TRUE?
A) The speed of motor will also decrease with decreasing temperature. B) The speed of motor will also increase with decreasing temperature. C) The speed of motor will also increase with increasing temperature. D) The speed of motor will also decrease with increasing temperature.
A sample of 100 resistors has an average resistance of 50 ? and a standard deviation of 5 ?. A second sample of 100 resistors has an average resistance of 100 ? and a standard deviation of 5 ?. If the two samples are combined, the standard deviation of all 200 resistances will be __________.
i. less than 5 ? ii. greater than 5 ? iii. equal to 5 ? iv. can’t tell from the information given
Technician A says that glycol-based brake fluid causes the seals to swell slightly. Technician B says the DOT 5 (silicone-based) brake fluid causes rubber seals to swell slightly. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B