Which part is splined to the clutch disc?
A) Input shaft B) Main gear
C) Cluster shaft D) Countershaft (lay shaft)
A
You might also like to view...
What pressure is present in a closed irrigation system when the water is not flowing?
a. dynamic c. head b. surge d. static
The output from a voltage divider changes with varying load conditions, and this fluctuation of voltage output is referred to as ____.
a. voltage regulation b. output regulation c. fluctuation regulation d. regulation
When a stall test is performed and the results are within specification but the transmission overheats, what is the likely problem?
A. engine malfunction B. stuck torque converter stator C. freewheeling torque converter stator D. differential carrier malfunction
You have been asked to design a bridge rectifier for a power supply. A step-down transformer has already been chosen. It will supply 12 V rms to your rectifier. The bridge rectifier is shown in Figure P9.43.
a. If the diodes have an offset voltage of 0.6 V, sketch the input source voltage vS (t) and the output voltage vo(t), and state which diodes are on and which are off in the appropriate cycles of vS (t). The frequency of the source is 60 Hz. b. If Ro = 1,000 ? and a filtering capacitor has a value of 8 ?F, sketch the output voltage vo(t). c. Repeat part b, with the capacitance equal to 100 ?F.