CAD/CAM is commonly used in modern manufacturing because it increases productivity over conventional manufacturing methods.
Answer the following statement true (T) or false (F)
True
You might also like to view...
What are fast side-to-side oscillations of the tire and wheel assembly called?
What will be an ideal response?
Answer the following statement(s) true (T) or false (F)
1. Pilot control devices are often employed to control the operation of a wound rotor induction motor. 2. The overload relay for a wound rotor motor contains two sets of contacts, both normally closed. 3. Four separate levers permit selection of the motor’s operating speed. 4. If the motor is operating and a lower speed is selected, it immediately decreases to the lower speed without time delay.
Mass air flow sensor voltage corresponds to:
A. engine load and crankshaft speed B. throttle opening and engine load C. engine and vehicle speed D. engine load and camshaft speed
In the float switch circuit, if the pump motor becomes overloaded, a(n) ____________________ stops the pump motor only.
Fill in the blank(s) with the appropriate word(s).