?The milling operation shown here is known as ____.
A. ?laser cutting
B. ?thermal cutting
C. ?climb milling
D. ?induced fracture cutting
Answer: D
Trades & Technology
You might also like to view...
?Which drilling operation is shown below?
A. ?spotfacing B. ?counterboring C. ?countersinking D. ?reaming
Trades & Technology
A hand tool used to mix concrete and patch holes is the _____.
a. short-handle shovel b. margin trowel c. edger/jointer d. pointing trowel
Trades & Technology
On a 240-volt residential branch circuit or feeder circuit with 10 AWG conductors, a maximum of a __________-ampere overcurrent protection device must be used.
a. 20 b. 25 c. 30 d. Any of the above
Trades & Technology
Federal regulations require that employees be protected from excessive noise in the workplace.