In the two-point perspective drawing the location of the ____ defines the size and position of the perspective when viewed from the station point (SP).
A. plan view
B. elevation view
C. picture plane
D. horizontal line
Answer: C
You might also like to view...
When there are several timers that meet the requirements of a given application, it is advisable to select the timer with the ____.
a. smallest number of operating parts b. lowest cost c. best reputation d. best support contract
maintenance ____________________ is a list of maintenance tasks and their suggested time interval.
Fill in the blank(s) with the appropriate word(s).
To read a dial caliper, ________ the reading on the dial to the reading on the blade
A) Subtract B) Add C) Multiply D) None of these
The computer will automatically clear a DTC if there are no additional detected faults after ________
A) Four key-on/ key-off cycles B) Two consecutive trips C) 80 warm up cycles D) 40 consecutive warm up cycles