(a) Load is applied to the three-hinged trussed arch in Figure P12.40 through the upper chord panel points by a floor beam and stringer floor system. Draw the influence lines for the horizontal and vertical reactions at support A and the forces or components of force in members BC, CM, and ML. (b) Assuming that the dead load of the arch and floor system can be represented by a uniform load of 4.8 kips/ft, determine the forces in bars CM and ML produced by the dead load. (c) If the live load is represented by a uniformly distributed load of 0.8 kip/ft of variable length and a concentrated load of 20 kips, determine the maximum force in bar CM produced by the live load. Consider both tension and compression. Joint E acts as a hinge.
Trades & Technology
You might also like to view...
The R-value of a concrete tilt-up wall is 1.20. What is its R-value considering air-to-air heat transfer through it?
What will be an ideal response?
Trades & Technology
What is radiated noise?
What will be an ideal response?
Trades & Technology
How can tube-in-tube condensers become contaminated?
A) Cross contamination can occur if the pressure drops. B) Cross contamination can occur if the pressure increases. C) Cross contamination can occur if the inside tube leaks. D) Cross contamination can occur if the outside tube leaks.
Trades & Technology
Safety data sheets (SDS) should be kept in a locked cabinet in the service manager's or supervisor's office.
Answer the following statement true (T) or false (F)
Trades & Technology