To make combustion efficiency tests, a hole must be made ____.
A. in the flue pipe after the draft control
B. in the flue pipe before the draft control
C. over the fire at the observation door
D. under the draft hood
Answer: B
You might also like to view...
Explain the importance of proper piston to cylinder clearance.
What will be an ideal response?
The thickness of polyethylene sheeting is measured in ____.
A. centimeters B. millimeters C. inches D. mils
A 1.4-m-long, 0.2-cm-diameter electrical wire extends across a room that is maintained at 20°C. Heat is generated in the wire as a result of resistance heating, and the surface temperature of the wire is measured to be 240°C in steady operation. Also, the voltage drop and electric current through the wire are measured to be 110 V and 3 A, respectively. Disregarding any heat transfer by radiation, determine the convection heat transfer coefficient for heat transfer between the outer surface of the wire and the air in the room.
What will be an ideal response?
What is a "CPA"?
A) Cold pack adapter B) Caller placement adapter C) Caliper pad adjuster D) Connector position assurance