The rate of taper can be determined if:
A. the large diameter and the small diameter are known
B. the large diameter and length are known
C. the large diameter, the small diameter, and the length of the tapered section are known
Answer: C
You might also like to view...
In his contest of wills with King John of England, Pope Innocent prevailed because he was
a. the wealthier of the two. b. the more astute politician. c. the more pious and spiritual. d. in possession of a larger army.
Assume that you are assigned to determine the minimum clamping force for a part to be molded out of polystyrene. The part cross-sectional area is 10 x 14 inches. What is the clamping force required if as a general rule, 2.5 tons of force are needed for each square inch of cross-sectional area?
What will be an ideal response?
If a duct-mounted electric heater is to be installed and it is discovered that the heater is too long to fit inside the duct (the duct is 10 inches high and 14 inches wide and the heater is 91/2 inches high and 18 inches long), what can the technician do to properly complete the installation?
A. Install the heater at an angle. B. Cut a slot in the duct work and allow the heater to protrude 4 inches out of the duct. C. Return the heater to the supply house and obtain the correct size heater. D. Cut the ends of the coils off the heater and increase the fan speed.
A PAL16H8 has 16 active high output pins
Indicate whether the statement is true or false