When are two-place decimal dimensions used?
What will be an ideal response?
Dimensions may appear on drawings as two-place decimals. These are widely used when the range of dimensional accuracy of a part is between 0.01" larger or smaller than a specified dimension (basic size). Where possible, two-place decimal dimensions are given in even hundredths of an inch.
You might also like to view...
A typical nitrogen cylinder is charged to a pressure of roughly _____.
a. 3,500 psig b. 2,000 psig c. 1,000 psig d. 250 psig
Ground-fault protection of equipment shall be provided for solidly grounded wye electric services of more than 150 volts to ground but not exceeding ____ volts phase-to-phase for each service disconnect rated 1000 amperes or more.
A. 500 B. 600 C. 750 D. 1000
Sulfur can be used to increase soil acidity and to reduce alkalinity
Indicate whether the statement is true or false
The current through a 16-?H inductor is zero at t = 0, and the voltage across the inductor (shown in Figure P4.14) is:
Determine the current through the inductor at .