When selecting solder to splice copper wire, which would be correct?
A. silver solder
B. rosin core
C. acid core
D. pure lead solder
Answer: B
You might also like to view...
Where is the ATF filter normally located?
A) At the pump inlet B) Screwed on to the side of the transmission C) Just after the ATF cooler D) None of these
The temperature of the compressed gas leaving the compressor can best be described as ____.
A. cold B. cool C. warm D. very warm
A desiccant wheel dehumidifier removes water from the air
A) by passing the air over a refrigerated evaporator coil B) by spinning the air until water is removed by centrifugal force C) by absorbing it in a chemical desiccant D) by passing the air through an open gas flame
The sum of the voltage drops in a series circuit equals the _________
A) Wattage
B) Source voltage
C) Amperage
D) Resistance