Holes for taper pins are usually prepared by ____.
A. drilling
B. broaching
C. milling
D. reaming
Answer: D
You might also like to view...
This type of plastic material is formed into a permanent shape by heat and pressure and cannot be altered by heating after curing.
a. plastic b. polymers c. thermoplastic d. thermoset
The term _______ best describes the absence of awkward bone structure and a smooth, even finish along the top and sides.
A. Balance B. Muscling C. Smoothness D. Soundness
What is the recommended transmission oil change interval when Eaton E-500 lubricant is used in a linehaul truck application?
A. 500 miles B. 50,000 miles C. 500,000 miles D. 5,000,000 miles
Where should the thermostat be mounted?
A) 36" to 48" above the floor on an inside wall B) 52" to 60" above the floor on an outside wall C) 52" to 60" above the floor on an inside wall D) 36" to 48" above the floor on an outside wall