The starter motor on a V-6 engine is being tested for starter amperage draw. The initial surge current was about 210 amperes and about 160 amperes during cranking. Technician A says that the starter is defective and should be replaced because the current flow exceeds 200 amperes. Technician B says that this is normal current draw for a starter motor for a V-6 engine. Who is right?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
B
You might also like to view...
The ____ of a brazed joint is its ability to withstand a force parallel to the joint.
A. shear strength B. tensile strength C. corrosion resistance D. ductility
To determine the synchronous speed of a motor, multiple 120 by the frequency of the supply current in hertz and divide their product by the ____.
A. output voltage in volts B. number of poles on the stator C. resistance of the rotor windings in ohms D. inductive reactance of the rotor in henries
Identify the differences between being a soil conservationist, a soil scientist and a soil engineer
What will be an ideal response?
The recommended method for applying the first layer of a built-up roof to prevent seepage of tar into the
rafter spaces is to _____. a. apply a layer of tar and allow it to dry before applying the first layer of felt b. apply a dry layer of felt, followed by the first layer of tar c. apply a layer of tar, followed by insulating boards that will absorb any excess tar d. place a flexible membrane over the decking, followed by the first layer of felt and asphalt