Which one is the right tooled joint to be used in given figure
A) decorative joint with a wood spacer
B) tooled dummy joint
C) tooled construction joint with expansion material
D) tooled construction joint
Answer: C
You might also like to view...
In the PCV system, crankcase vapors are recycled to the:
A. exhaust system. B. air cleaner housing.. C. oil-breather cap. D. intake manifold.
Problem 1.52 Solve Prob. 1.51, assuming that the structure has been redesigned to use 5/16-in.-diameter pins at A and C as well as at B and that no other changes have been made. Problem 1.51 Link AC is made of a steel with a 65-ksi ultimate normal stress and has a 14× 12-in. uniform rectangular cross section. It is con¬nected to a support at A and to member BCD at C by 38-in.-diameter pins, while member BCD is connected to its support at B by a 5 16-in.-diameter pin. All of the pins are made of a steel with a 25-ksi ultimate shearing stress and are in single shear. Knowing that a factor of safety of 3.25 is desired, determine the largest load P that can be applied at D. Note that link AC is not reinforced around the pin holes.
Plywood veneer grade ____ is smooth, paintable, and does not have more than 18 neatly made repairs, boat, sled or router types.
A. A B. B C. C D. D
What information in a drawing?s title block identifies the project?