El tipo de soporte de barra que usaría en una situación en que no hay tolerancia al óxido es de Clase _____.
a. A
b. B
c. C
d. D
Answer: D
You might also like to view...
Which of the following statements is LEAST-Likely true?
A. Checking voltage drops as a preventive maintenance measure will catch potential problems before they fully develop. B. A small amount of voltage drop through the fuse link, which is a smaller wire than the rest of the circuit, is normal. C. There are no fuse links in the ground circuit, so lower voltage drop (0.1 volt) is desired. D. When performing a voltage drop test, remember that current must not be running through the circuit.
The _____ pen is used when doing mechanical lettering.
A. tapered B. bevel C. mechanical D. straight
The subsequent problems deal with the figure and table below
For a Type J (Iron-Constantan) thermocouple configuration (as shown above) with a 0°C reference (Tref):
where Vemf is the voltage difference produced by the junction pair (Vemf = VA ? VB in the figure).Assume that nodes A and B are at the same temperature, unless indicated otherwise. Assume that the op amp is ideal.If we measure a 20°C input with a 10°C reference, the voltage between nodes A and B would be?
A. 1.526 mV B. 0.507 mV C. 0 mV D. 1.019 mV E. 0.512 mV
How many terminals are in an OBD-II DLC (Data Link Connector)?
a. 4 b. 8 c. 12 d. 16 e. 32