Mechanical fade is usually a result of overheated drums.

Answer the following statement true (T) or false (F)


True

Trades & Technology

You might also like to view...

Two technicians are discussing the proper procedure for bleeding air from a power steering system. Technician A says that the front wheels of the vehicle should be lifted off the ground before bleeding. Technician B says that the steering wheel should be turned left and right with the engine off during the procedure. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

The evaporation process occurs when:

A) A liquid is below its critical pressure. B) A liquid is above its critical temperature. C) A liquid has reached critical mass. D) A liquid is below its boiling point.

Trades & Technology

What is a low water cut out?

A) it is an operating control that shuts off the boiler at the end of every operating cycle when it senses that the boiler has used up its supply of water B) it is a safety device that shuts off the boiler if the water level is low C) it is an operating control that energizes the water fill solenoid at the end of an automatic blow-down cycle D) it is a hand valve installed near the bottom of the boiler that is used for filling and servicing the boiler

Trades & Technology

When the power is 220 watts and the resistance is 100 ohms, what voltage is in the circuit? Carry the answer to two decimal places.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology