If two power-side insulated wires were to melt together to the point that the copper conductors touched each other, the type of failure would be called a(an) ________.
A) Short-to-voltage
B) Floating ground
C) Short-to-ground
D) Open
A) Short-to-voltage
You might also like to view...
What does the control cartridge mechanically move to manage an effective stroke in a single-actuator EUI?
A. pumping plunger B. barrel C. nozzle needle D. poppet control valve
A direct expansion-type evaporator is also called a ____.
A. flooded evaporator B. dry-type evaporator C. multi-circuit evaporator D. stamped evaporator
What is the purpose of radiator air vents at terminals on one-pipe systems?
What will be an ideal response?
Technician A says that engine block cylinders are measured for taper. Technician B says that the piston rings typically cause the most wear in the middle of the cylinder. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B