The difference between what is acceptable, fit for service, and perfection is known as ____________________.
Fill in the blank(s) with the appropriate word(s).
tolerance
Trades & Technology
You might also like to view...
What is the purpose of the crop?
What will be an ideal response?
Trades & Technology
If the positional tolerance of the hole in problem 2 above is zero at MMC, then what would the positional tolerance be at the actual produced sizes given below?
Trades & Technology
Technician A says that a semi-independent rear suspension is used with live rear axles. Technician B says that the semi-independent rear suspension is used only with non-drive rear axles. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Trades & Technology
________ studs are the bearing support for wall headers in framed openings
A) Finger jointed B) Jack C) Engineered lumber D) Cripple
Trades & Technology