How much current flows in the circuit in Figure 11-1 if connected to a 12 VPP, 2 kHz source?
A) 10.1 mAp-p B) 60.5 mAp-p C) 126 mAp-p D) 4.77 mAp-p
A) 10.1 mAp-p
You might also like to view...
Technician A says that oxygen sensors can be tested using a test light or jumper wire. Technician B says conditions can occur that cause the oxygen sensor to be fooled and give a false lean or false rich signal to the PCM. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
The formula for calculating the CFM needed to produce an air change is
A) CFM = (floor area × ceiling height) / 8 B) CFM = (floor area × ceiling height) / 60 C) CFM = floor area × ceiling height D) CFM = (floor area × ceiling height) / 12
What regulates the draft through the heat exchanger and prevents downdrafts from blowing into the heat exchanger on natural draft gas furnaces?
A) The draft regulator B) The barometric damper C) The draft diverter D) The induced draft blower
How does a vapor retarder under a concrete slab-on-ground affect the stresses caused by the shrinkage of the concrete slab?
What will be an ideal response?