Another common name for lineman pliers is _____

a. locking pliers
b. tongue-and-groove pliers
c. needle-nose pliers
d. side cutters


d

Trades & Technology

You might also like to view...

The transmission is in first gear, which has a 2.5:1 ratio, and the rear axle has a ratio of 2:1. The overall gear ratio is ________.

A) 5:1 B) 2:1 C) 2.5:1 D) 4.5:1

Trades & Technology

A sacrificial anode on a gas water heater should be replaced when its diameter decreases to _____.

a. 1-1/8 inches b. 7/8 inch c. 5/8 inch d. 3/8 inch

Trades & Technology

In a stick-built glass curtain wall system, the mullions may span floor to floor (called single-span mullion system) or between two floors (called twin-span mullion system). In the single -span mullion system, each mullion is provided with a dead load anchor and a tieback. In this support system, which anchor (dead load anchor or tieback) is provided at the top of each mullion?

What will be an ideal response?

Trades & Technology

All of these could cause the wiper motor to run but NOT move the wipers, EXCEPT ________

A) Stripped gears in the gearbox B) Loose linkage to the motor connection C) Loose or separated motor-to-gearbox connection D) Poor ground connection at the wiper switch

Trades & Technology