When there is a hole in the part, the part is at LMC when the dimension is at its lowest limit and at MMC when the hole is at its upper limit.

Answer the following statement true (T) or false (F)


False

Trades & Technology

You might also like to view...

A ground source heat pump needs a heat exchange bed?  square feet in size.  So far, an area of  square feet has been excavated.  Find the area that still needs to be dug.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

If no current flows through the base of the transistor, the transistor acts like a closed switch.

Answer the following statement true (T) or false (F)

Trades & Technology

___________ lime contains calcium and magnesium

Fill in the blank(s) with correct word

Trades & Technology

How is placement of the evaporator line determined when drawing a PH diagram of an operating system?

A) The evaporator line is always drawn on the horizontal line representing 50 psia absolute pressure. B) Draw a horizontal line across the saturation curve on the constant pressure line equal to the system low side absolute pressure. C) The evaporator line can be drawn anywhere that crosses the saturation curve as long as it is a horizontal line. D) Draw a vertical line across the saturation curve on a constant enthalpy line equal to the system low side absolute temperature.

Trades & Technology