What is the purpose and function of an accumulator?

A) To apply a band
B) To apply a clutch
C) To cushion or dampen pressure surges
D) Either A or B


C

Trades & Technology

You might also like to view...

IDENTIFY TEST PROCESS SYMBOLS AND DIAGRAMS

Trades & Technology

Given the following information, determine the burdened hourly wage rate for a carpenter. Assume the carpenters take full advantage of the retirement benefit.

Wage rate—$23.00 per hour Hours worked—45 hours per week for 30 weeks, and 40 hours per week for 20 weeks Vacation, holidays, and sick leave—Two weeks at 40 hours per week Overtime—Time-and-a-half for any hours over 40 per week Gas allowance—$150 per month Annual bonus—$300 Social Security—6.2 percent on the first $127,200 of wages Medicare—1.45 percent of all wages FUTA—0.6 percent on the first $7,000 of wages SUTA—5.8 percent on the first $10,000 of wages Worker’s compensation insurance—$12.25 per $100.00 of wages General liability insurance—0.55 percent of wages Health insurance (company’s portion)—$450 per month per employee Retirement—$0.50 per $1.00 contributed by the employee on 6 percent of the employee’s wages

Trades & Technology

Which of the following is not part of the operating sequence of a natural-draft furnace?

a. The draft inducer starts on a call for heat. b. The controls prove that the pilot is lit. c. The gas valve energizes and opens. d. The fan switch starts the blower.

Trades & Technology

You have been receiving more complaints lately that the phones are not getting answered quickly enoughNthere is too long of a delay to get waited onNand that the paperwork is never ready on time. You have 18 technicians and three service consultants. Worst of all, the complaints do not seem to be directed toward any one individual but seem to be occurring throughout your shop. Where do you think

the bottleneck is most likely to be occurring? A) Parts specialist B) Dispatcher C) Shop foreman D) Service consultant

Trades & Technology