When beveling the ends of a pipe, the sharp inner edge of the bevel should be ground flat, forming a chamfer. This area is called a(n) ________________________.
Fill in the blank(s) with the appropriate word(s).
land
Trades & Technology
You might also like to view...
Which of these can cause a starter grinding noise?
A) An overtightened flywheel B) Defective starter drive C) Seized engine D) Neutral safety switch
Trades & Technology
When the S input of an S-R latch is HIGH and the R input is LOW, the latch is in the
A) SET state. B) CLEAR state. C) RESET state. D) Cannot be determined.
Trades & Technology
If the field coil of a shunt DC motor opens, the speed of the shaft will __________.
A. slow down B. speed up C. stay the same
Trades & Technology
What would be the incident command designation for the 7th floor on a high-rise?
A. Sector 7 B. Sixth floor C. Division 7 D. Level 6
Trades & Technology