Typical TP sensor voltage at idle is about ________
A) 1.5 to 2.8 volts B) 2.50 to 2.80 volts
C) 0.5 volt or 10% of WOT TP sensor voltage D) 13.5 to 15.0 volts
C
You might also like to view...
If you are given a choice of using either reactive or proactive routing protocol, which one would you prefer for P15.7 with ad hoc network and why?
One method of measuring salinity in water is to gauge the:
a. amount of oxygen c. amount of dissolved oxygen b. electrical conductivity d. levels of calcium
When installing the outdoor unit of a split-system air-source heat pump, it is important to locate the unit:
A) Below the frost line to reduce defrost cycles. B) As close to the house as possible to help shelter the unit from inclement weather. C) Under an overhang for protection against the weather. D) Above the snow line of the area.
Consider the series springs shown in accompanying figure. Realizing that the total deflection of the springs is the sum of the deflections of the individual springs, and the force in each spring equals the applied force, show that for the springs in series, the equivalent spring constant ke is
