Isometric drawings are well suited for
a. Floor plans
b. Plot plans
c. Exploded assembly views
d. Auxiliary views
e. Working drawings
C
You might also like to view...
If a dam were built to create a reservoir impounding part of the Ganges, what characteristic trophic state might you expect for the reservoir? Explain your answer.
The Ganges River, shown in Figure 4.66, has an annual average flow rate of 12,105 m3/s. The average temperature of the Ganges River was reported to be 24.6ºC. The Ganges has become contaminated with raw sewerage and industrial waste so that the dissolved oxygen in the river upstream of sewerage discharges is 4.6 mg/L. Suppose that the raw sewerage that is untreated flows into the Ganges at a rate of 460 m3/s, the temperature is 25ºC, and the dissolved oxygen in the sewerage stream is completely depleted (i.e. DO = 0). How would you develop a plan for improving water quality in the Ganges River? What will be an ideal response?
Division 15 deals with
A. Site work B. Equipment C. Mechnical D. General Requirments
Which of these angles is most commonly used for valve seats?
A) 65° B) 45° C) 15° D) 30°
The correct location for the pads when hoisting or jacking the vehicle can often be found in the ________
A) Owner's manual B) Shop manual C) Service manual D) All of the above