Flat taper may be specified as:
A. flat taper per inch, flat taper as a ratio, or conical taper
B. flat taper per inch, flat taper as a ratio, or flat taper in degrees
C. flat taper per inch, Morse taper, or flat taper as a ratio
D. ?
Answer: B
You might also like to view...
The term ____________________ percentage is used to indicate the percentage or yield of hot carcass
weight to the weight of the animal on foot.
Fill in the blank(s) with the appropriate word(s).A suspended object will always tilt or move so that the center of gravity is always _______ the lift point
Fill in the blank(s) with correct word
Solids that float on liquids are called ____________________.
Fill in the blank(s) with the appropriate word(s).
In a wastewater cooled system, the difference between the condensing temperature of the refrigerant and the leaving water temperature is approximately ____.
A. 10°F B. 20°F C. 30°F D. 40°F