?Technician A says that the amount of taper a cylinder bore has can be determined using a piston ring and a feeler gauge. Technician B says that the greatest cylinder bore out-of-round wear will occur at the wrist pin ends of the piston. Who is right?

A. ?Technician A only
B. ?Technician B only
C. ?Both A and B
D. ?Neither A nor B


Answer: A

Trades & Technology

You might also like to view...

The ____ position is the most commonly used pipe welding position.

A. 6G 45 degree inclined B. 2G vertical fixed C. 5G horizontal fixed D. 1G horizontal rolled

Trades & Technology

The vehicle safety certification label includes all of these EXCEPT ________

A) Tire pressure recommendation B) GAWR C) GVWR D) VIN

Trades & Technology

This is a measure of the impact human activities have on the environment in terms of the amount of greenhouse gases produced, measured in units of carbon dioxide:

A. carbon offset B. carbon footprint C. carbon dioxide D. carbon usage E. none of the above

Trades & Technology

Convert  0.875 into an equivalent fraction or mixed number reduced to lowest terms.

What will be an ideal response?

Trades & Technology