Which of the following operations cannot be selected through the section object's shortcut menu?
a. Change the type of section object
b. Activate live sectioning
c. Change the section object settings
d. Create 2D/3D sections
A
You might also like to view...
The longest cutback line for a 45-degree miter for a 90-degree turn on a piece of 4-inch pipe (4.5 inch OD) would be _____ inches.
a. 15/16 b. 2 c. 2-1/4 d. 2-7/8
How would you check the drive shaft balance without special instruments?
What will be an ideal response?
When torquing intake manifold bolts, what is the proper sequence?
A) From one end to the other end B) From the center to the outer ends C) The sequence is not important D) From both ends, then in towards the center
Which description best describes heat transfer by conduction?
A. A cooking pot heated on an electric stove element. B. Heat rising of a baseboard heater. C. Heat from the sun. D. All of the above.