After servicing the air filter on an ETC equipped vehicle, the technician has forgotten to connect the throttle motor wiring. What will happen when the vehicle is started?
A) The engine will perform normally, but the cruise control will not work
B) The engine will start but not accelerate; idle speed between 1200 and 1600 RPM
C) The engine will start but not idle
D) None of the above
B
You might also like to view...
Ten years ago, JD and his colleagues resigned from a major aerospace corporation, after many years of salaried employment, to form JRG Solar, Inc. with the intent to make a significant impact on the international renewable energy market based on years of design and test work in neighborhood garages of the three partners. Additionally, they hoped to make at least 10% per year on their own and other investors’ financial commitment to JRG Solar. They were successful in obtaining $12 million in capital funding to start the business. JD, who has always been the one most interested in the economic return side of the business, recently looked at the 10-year NCF series of JRG Solar (shown below in $1000 units). When he did a quick analysis on a spreadsheet, he saw that the IRR over the 10
years was 11.26% per year. He was very pleased with this return; however, he noticed that the NCF and cumulative cash flow (CCF) series both indicated multiple i* values.
During this 10-year start-up phase of JRG Solar, the average investment rate for positive cash flows has averaged 4% per year. Since the investment rate is quite low for corporate retained earnings, and because the two rules-of-sign-changes indicate multiple roots to the ROR equation, JD wants to understand the results of an ROR analysis beyond that of the simple ROR result (i* = 11.26%) that he obtained using the IRR function on the NCF series. Perform an ROIC analysis for JD to determine if JRG Solar’s owners are realizing the MARR of 10% per year that they anticipated.
 FIGURE 1.png)
When making leaders, make them:
a. Cross each other
b. Horizontal or vertical
c. Near each other and parallel
d. Through a corner of the view
e. Longer than needed
A tire used on a truck rear axle has premature wear at both wall sides of the treads. What is the most likely cause?
A. overinflation B. underinflation C. excess toe D. excess caster
What are the four primary parts of programmable logic controllers?
What will be an ideal response?