The shim used on a drive pinion gear is used to properly position the gear so that it can correctly mesh with the ________
A) Ring gear B) Side gear
C) Differential pinion gears D) Both B and C
A
You might also like to view...
How much could BTU Oil & Gas Fracking afford to spend on new equipment each year for the next 3 years if it expects a profit of $50 million 3 years from now? Assume the company’s MARR is 20% per year.
What will be an ideal response?
Technician A says that most digital and analog (needle-type) dash gauges use variable resistance sensors. Technician B says that permanent-magnet (PM) generators produce an AC signal and are used for vehicle speed and wheel speed sensors. Who is right?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Using Ohm?s law, find I when the voltage V = 9.3 V and R = 1.5 k?
What will be an ideal response?
If you are bypassing a starter relay switch using a jumper wire, what component is being tested?
A. starter solenoid B. ignition key C. battery bank D. starter relay/ mag switch