The striking face of a ball peen hammers is used to strike which of the following?
A. chisels and punches
B. nails
C. metal ductwork
D. hex keys
Answer: A
You might also like to view...
What are the possible effects of a changing climate on economic systems, ecosystems, social structures, and technological challenges that may lie in the future?
What will be an ideal response?
The bottoms of the studs are held in position by a bottom (or ____) plate.
A. sole B. partition C. rafter D. joist
Which part MUST be used when refitting a vehicle from R-12 to R-134a refrigerant?
A) A new condenser B) A new service fitting and a retrofit label C) A high pressure cutoff switch D) Both B and C
Technician A says that most horn circuits use a relay and the current through the relay coil is controlled by the horn switch or body control module. Technician B says that most windshield wipers use a two-brush, three-speed motor. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician