Which of the following is not a type of dimensioning system used on technical drawings in the U.S.:
A. metric dimensioning
B. decimal-inch dimensioning
C. proportional dimensioning
D. fractional dimensioning
Answer: C
You might also like to view...
Two wind turbines each produced power for 
?hours one day. In addition, 9 other turbines produced for 
hours each. What is the total time these turbines produced power that day?
Fill in the blank(s) with the appropriate word(s).
? Identify and state the historical significance of Dr.Elizabeth Blackwell.
What will be an ideal response?
Which of the following can be a result of overcrowding?
a. Increased death rate b. Low stress level c. Increased reproduction d. None of the above
A starting system voltage drop test is being done. Technician A says the higher the voltage drop, the lower the resistance in the circuit. Technician B says a high-voltage drop in the cranking circuit wiring can cause slow engine cranking. Who is right?
A) Technician A only B) Technician B only C) Both A and B D) Neither A nor B