When a casting, forging, or welded part is to be finished all over, the drawing is simplified by omitting the finish symbols and adding the note: ____.
A. ALL OVER
B. ALL OVER FINISH
C. FINISH
D. FINISH ALL OVER
Answer: D
You might also like to view...
The secondary current in a constant-current transformer is typically between _____.
a. 0.5 and 1A b. 1A and 2A c. 4A and 7.5A d. 10A and 20A
The wet-bulb depression is ____.
A. the difference between dry- and wet-bulb temperatures B. the same as the wet-bulb temperatures C. the same as the dry-bulb temperatures D. when the air is saturated with moisture
?What layout tool can be used to mark a straight line by dragging it along the straight edge of plate while holding a piece of soapstone against the end of the tool?
A. ?straight edge B. ?12' tape measure C. ?framing square D. ?combination square
Wooden roof framing by conventional or ____ is accomplished by spanning from wall to wall with ceiling joists and from double top plate to ridge board with rafters.
A. web framing B. stick framing C. rafter framing D. joist framing