The valve body bores are being discussed: Technician A says the bores should be measured with small bore (hole) gauges. Technician B says the bores only need to be cleaned if the damage to the valves can be corrected by polishing. Who is correct?
A. A only C. Both A and B
B. B only D. Neither A nor B
D. Neither A nor B
You might also like to view...
The use of a time-delay, low-voltage release device provides the safety of ____.
a. spike control b. high-voltage protection c. three-wire control d. two-wire control
Construction lines are thin lines that are drawn __________ on the plans.
Fill in the blank(s) with the appropriate word(s).
Which of the following dogs belongs in the Hound Group?
A. Welsh Terrier B. Labrador Retriever C. Poodle D. Beagle
New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician