How would you use a test light?
What will be an ideal response?
To use a test light:
- Verify that the bulb is good by connecting the test light clamp to the negative terminal of the battery and touching the pick to the positive terminal. The test bulb should light.
- Connect the clamp to the battery negative post, always.
- Probe where necessary on the power side of the circuit with the pick end. A lighted bulb means there is power at this point.
You might also like to view...
Which of the following describes a Myers hub?
a. A type of duct system b. A gasketed locknut c. A gasketed fitting d. An insulated bushing
?The _____ circle is what the cam would be if there were no lobe.
What will be an ideal response?
The total resistance of a series circuit is equal to the ____________________ of resistances of all resistors in the circuit.
Fill in the blank(s) with the appropriate word(s).
Identify the tests used to find potential defects in welds that are performed without destroying or damaging the weld or the part.
What will be an ideal response?