Match each item with a statement below.
A. The measurement of the heat loss of a particular window or door assembly.
B. The measurement of how much of the sun's radiation a window or door will block.
C. A measurement of how much light comes through glazing.
D. Helps to control solar gain when extra heat is not needed.
E. Makes use of low-emissivity coatings that block much of the infrared energy and ultraviolet light while allowing in most of the visible light.
F. Is often specified for high-security areas where light is desired but a view is not needed.
A. U-factor
B. Solar heat gain coefficient (SHGC)
C. Visible transmittance (VT)
D. Shading fenestration
E. Spectrally selective glass
F. Glass block
You might also like to view...
? Identify and state the historical significance of protective tariff.
What will be an ideal response?
With what must the nozzle spray pattern be compatible for proper mixing?
A) mix of oil and air B) burner air pattern C) orifice D) spray angle
Which of the following is not normally found on a PLC?
A) Monitor B) Keyboard C) Hard disk drive D) All of the above
For a given PLD, if none of the input to the OR gate are connected, the output of this gate will be:
A) LOW. B) HIGH. C) tri-state. D) invalid.