IDENTIFY TEST PROCESS SYMBOLS AND DIAGRAMS
Gas turbine
You might also like to view...
Technician A says excessive drive belt tension can cause wear on the upper, front main bearing. Technician B says maintaining proper oil clearance and a lower viscosity oil will increase the fatigue life of a bearing. Who is right?
A. Technician A B. Technician B C. Both technicians D. Neither technician
Remember Pascal's law: Pressure is equal everywhere in an enclosed system.
Answer the following statement true (T) or false (F)
What is the purpose of the discharge line thermostat?
A) To ensure that the discharge air is always warm in the heating cycle B) To prevent the compressor from operating at temperatures that will cause oil breakdown and loss of lubrication C) To shut off the compressor if the superheat gets too low D) To keep the discharge air from exceeding 200°F in the heating mode
Battery cases and terminals should be cleaned with:
A. Soap and water B. Engine shampoo C. A solution of baking soda and water D. A steam cleaner