The Geometric Dimensioning and Tolerancing drafting language was developed over many years is now the international standard.
Answer the following statement true (T) or false (F)
True
Trades & Technology
You might also like to view...
____ varieties of steel are slightly oversize and have slightly rounded corners.
A. Hot-tempered B. Hot-rolled C. Cold-tempered D. Cold-rolled
Trades & Technology
When using a saw to cut cellular glass, the _____.
a. saw should be a coarse tooth design b. insulation must not have a jacket applied c. saw’s teeth tend to wear down quickly d. kerf should be minimized for a tight fit
Trades & Technology
Isometric drawings are _____.
a. elevations b. plan views c. not drawn to scale d. scaled
Trades & Technology
Which instrument should be used to verify that there is power available to run a three-phase motor that will
not start? a. Clamp-on ammeter b. Megger® c. Ohmmeter d. Voltage tester
Trades & Technology