Technician A says that oil for the rod bearings comes from splash off the crankshaft. Technician B says that lubrication to the main bearings is fed through the main oil gallery in the block. Who is right?

A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B


B

Trades & Technology

You might also like to view...

If two power-side insulated wires were to melt together to the point that the copper conductors touched each other, the type of failure would be called a(an) ________.

A) Floating ground B) Short-to-voltage C) Short-to-ground D) Open

Trades & Technology

The American Breeders Service reports that one of its superior bulls produced over _______ ampules of semen

a. 12 c. 24,200 b. 12,000 d. 462,000

Trades & Technology

After a TP sensor has been tested using the MIN/MAX function on a DMM, a reading of 5 volts is displayed. What does this reading indicate?

A) The TP sensor is open at one point during the test B) The TP sensor signal is shorted to 5-volt reference C) The TP sensor is shorted D) Both B and C are possible

Trades & Technology

The Schrader valves commonly found on system service valves create a restriction even when they are in the open position.  __________ can be used to remove the Schrader pins for evacuation and to replace the pins after the proper vacuum has been achieved.

What will be an ideal response?

Trades & Technology