The proper order for repairing a system after identifying a leak in a brazed joint on the discharge line is to:

A) Recover the refrigerant, repair the leak, leak test the system, evacuate the system, charge the system with refrigerant.
B) Recover the refrigerant, leak test the system, repair the leak, evacuate the system, charge the system with refrigerant.
C) Charge the system with refrigerant, repair the leak, recover the refrigerant, leak test the system, evacuate the system.
D) Leak test the system, repair the leak, recover the refrigerant, evacuate the system, charge the system with refrigerant.


A

Trades & Technology

You might also like to view...

While discussing direct fuel injection (DFI), Technician A says the DFI injector may require a special tool to remove it from the cylinder head. Technician B says the DFI high-pressure fuel line from the high-pressure pump to the fuel rail can be reused only twice before replacement. Who is correct?

A. Technician A B. Technician B C. Both A and B D. Neither A nor B

Trades & Technology

If two power-side insulated wires were to melt together to the point that the copper conductors touched each other, the type of failure would be called a(an) ________.

A) Short-to-ground B) Short-to-voltage C) Open D) Floating ground

Trades & Technology

When setting up the welding equipment for GMAW on aluminum pipe, the proper shielding gas to use is

_____. a. propane b. acetylene c. an argon/carbon dioxide mix d. argon or an argon/helium mix

Trades & Technology

The compressor in a refrigeration system ____.

A. raises the boiling point of the refrigerant B. pumps the refrigerant throughout the system C. both a and b D. none of the above

Trades & Technology