The _____ of a resistor indicates the plus and minus limits of a resistor's ohmic value.
A. tolerance
B. resistance
C. coefficient
D. wattage
Answer: A
You might also like to view...
Round sheet metal ductwork should be:
A) Fastened and sealed with duct tape. B) Fastened with sheet metal screws and sealed with mastic. C) Fastened with duct tape and sealed with mastic. D) Fastened and sealed with mastic.
A sling psychrometer can be used to determine the relative humidity by comparing:
A) The psychrometer reading to a barometer reading. B) The still reading and the moving reading. C) The psychrometer reading to the manufacturer's charging chart. D) The dry-bulb and wet-bulb readings.
In the switched-mode power supply of Figure P12.38, sketch the load voltage signal vo.
Which of the following is defined as a reduction in the primary air intake area that reduces the amount of gas being burned and results in a smaller, soft, and lazy flame?
a. overfiring b. underfiring c. spud d. high efficiency