The fifth step in using a Karnaugh map is to ____.
A. plot the logic functions by placing a "1" in each square representing a term
B. obtain the simplified logic function by looping adjacent groups of 1s in groups of eight, four, or two
C. "OR" the loops with one term per loop
D. write the simplified expression
Answer: D
You might also like to view...
Which of the following statements is LEAST-Likely true?
A. Checking voltage drops as a preventive maintenance measure will catch potential problems before they fully develop. B. A small amount of voltage drop through the fuse link, which is a smaller wire than the rest of the circuit, is normal. C. There are no fuse links in the ground circuit, so lower voltage drop (0.1 volt) is desired. D. When performing a voltage drop test, remember that current must not be running through the circuit.
If the compression ratio of a system with a reciprocating compressor decreases, the amount of refrigerant pumped by the compressor ____.
A. will increase B. will decrease C. will remain the same D. cannot be determined
Which of the following can be used to characterize corporate culture?
a. shared experiences b. shared stories c. shared beliefs d. All of these are correct. e. None of these are correct.
The right column contains the three steps and functions of the process scan cycle. Identify the letters of the steps and their functions in the proper order on the lines in the left column. I. ___ A.SCANPROGRAM INSTRUCTIONS ___B.Checks the input image table to determine the status of the inputs ___C.UPDATES OUTPUT DEVICES D.Writes the decision into the output image tableII. ___ E.UPDATE INPUT TABLE ___F.Senses the voltage levels of the input terminals ___G.Makes logic decisions based on input conditions ___H.Stores the status of the input terminals as 0s and 1s into the corresponding bit of memoryIII. ___ ___I.Takes data from output image table and converts it to a voltage at the output terminals
What will be an ideal response?