What is the feed rate in IPM for a 1/2 inch diameter, two-flute end mill with a cutting speed of 100 SFPM and a feed per tooth rate of .003 inch?
A) 1.6 B) 2.8 C) 3.8 D) 4.8
D
You might also like to view...
Technician A says that a data packet in a typical J1939 transaction consists of 7 fields. Technician B says that each field in a J1939 data packet has identical data volume. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Technician A says that adjustable end wrenches should be used to tighten fasteners. Technician B says that adjustable end wrenches can round the edges of fasteners. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
What is the output voltage at the end of the input pulse from an RL integrator that uses a 400 mH inductor, a 5 k? resistor and a 5 V, 1.2 ms input pulse?
A) 4.532 V B) 3.16 V C) 5 V D) 4.75 V
A(n) ____ is a similarity between two unlike things.
A. analogy B. analysis C. synectic D. sketch