The ____ is an allowance for the extra material required to fill volumes with compacted material rather than loose material.
A. growth factor
B. stability factor
C. compaction factor
D. compression factor
Answer: C
You might also like to view...
_____ is done by holding the plumb rule at an angle on the edge of the corner of the brick at the racking point to check the alignment.
A. Returning B. Racking back C. Tailing a lead D. Holding the line
If the population of a country in 2010 was 72 million and the projected exponential rate of increase is 6.3 per 1,000, what total percentage reduction of environmental impact per GDP will be required by 2050 to keep the environmental impact at the 2010 levels if the GDP per capita is predicted to increase at a rate of 5% per year between 2010 and 2050?
What will be an ideal response?
Batteries are a good example of:
A) Conversion of chemical energy into electrical energy. B) Conversion of heat energy into mechanical energy. C) Conversion of electrical energy into heat energy. D) Conversion of mechanical energy into electrical energy.
Answer the following statement(s) true (T) or false (F)
1. Many engineering problems are modeled using differential equations with a set of corresponding boundary and/or initial conditions. 2. Boundary conditions provide information about what is happening physically at the boundaries of a problem. 3. Initial conditions tell us about the initial conditions of a system (at time t = 0), before a disturbance or a change is introduced.